Pulley / shaft assemblies are available form CCI_complete with properly seated bushings, mounted bearing units, take-up frames, and drive sprockets or reducers.
Standard C1045 shafting will be supplied unless otherwise specified.
Other shafting configurations are available upon request, journals, drill & taps, special finish, etc.
| Shaft Length ....................................... | A | = | __________ |
| Shaft Diameter ................................... | D | = | __________ |
| Pulley Face To Shaft End ................ | C1 | = | __________ |
| C2 | = | __________ | |
| Pulley Face Width ............................. | B | = | __________ |
| Drive Key Length .............................. | E | = | __________ |
| Bushing Key(s) Length ..................... | F | = | __________ |
| *Standard key seat per shaft diameter will be supplied unless otherwise specified. | |||